Select Page
Petite Bubbles

Petite Bubbles

01. Ready to Tack Fuse I’d like to say that I purposely skipped the photographs to get these petite projects to this stage, but I forgot! But, in my defense, this larger project here has all of the exact same steps, just bigger. But to recap, the blue chunks of...
Bubble Coasters

Bubble Coasters

01. Bubble Sandwich Because I’ve already shown how the 2mm stringer is tack fused and then cut to form the two sides of the this bubble sandwich, I thought I’d just jump right to the final fusing. These smaller bubble projects are intended as coasters and...
Bubble Plate Green

Bubble Plate Green

01. Stringers and Spacers In this photo, I’ve already cut the clear Tekta glass for the plates (3mm thick, 10 x 8 inches). There are also a couple of small coasters I’ll be doing off to their left. The plates and coasters are sitting on a set of four small...
Bubble Plate Red

Bubble Plate Red

01. Stringers and Spacers I’ve already cut the clear Tekta glass (3mm thick, 10 x 8 inches). It’s sitting on a set of four small ceramic dam pieces, elevating it from my gray cutting mat just to make it easier to pick up later.  For the green lines I used...
Bubble Plate

Bubble Plate

01. Stringers and Spacers This project came directly from an ebook called Fused Glass Bubble Sorcery. Though it called for a final plate size of 6″ x 8″, I wanted an 8″ x 8″ square so adjusted the glass sizes accordingly. For the blue lines I...