Select Page
Cherry Blossom Bowl

Cherry Blossom Bowl

01. Three Circles No sooner had I finished a test with Ruth’s enamel kit, I knew I wanted to create a big bowl, which I’ve never done before. The first thing I did was cut the circles that would become the three layers of the bowl. I used Bullseye Glass,...
Bubble Plate Green

Bubble Plate Green

01. Stringers and Spacers In this photo, I’ve already cut the clear Tekta glass for the plates (3mm thick, 10 x 8 inches). There are also a couple of small coasters I’ll be doing off to their left. The plates and coasters are sitting on a set of four small...
Bubble Plate Red

Bubble Plate Red

01. Stringers and Spacers I’ve already cut the clear Tekta glass (3mm thick, 10 x 8 inches). It’s sitting on a set of four small ceramic dam pieces, elevating it from my gray cutting mat just to make it easier to pick up later.  For the green lines I used...
Cherry Blossom Coasters

Cherry Blossom Coasters

01. Three Colors of Glass I know it’s hard to see the clear glass squares at far right, but you’ll have to take my word for it that they’re there. In order to make two coasters, I cut two 3.5 x 3.5 inch squares of the following Bullseye Glass, all...
Pendants

Pendants

01. Pattern Bar This tiny pattern bar is my first attempt at faux murrine. I used 3mm thick, 1/4″ wide strips of French Vanilla sheet glass surrounding Turquoise Blue 2mm stringer. I’ve dammed it and put ceramic fiber paper between glass and dam. Below you...